LiftMaster MGJ Installation Manual - Page 13
Setup Radio Antenna, Option
View all LiftMaster MGJ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
TYPICAL INSTALLATION INSTALL 3-BUTTON CONTROL STATION 4 Connect wires to the control station and replace the control station cover. Power 5 Fasten the entrapment warning placard next to the control station. AUX AANUT X ANT AUX ANT ^^^^ TTC LEARN STOP CLOSE OPEN LEDD14 1 2 3 4 5 6 7 LMEP1 LMEP2 COM INTRLK STOP CLOSE OPEN Logic Board Remove factory jumper if external interlock is used. Control R27 TTC LEARN STOP CLOSE OPEN LEDD14 1 2 3 45 67 LMEP1 LMEP2 COM INTRLK STOP CLOSE OPEN Stop Close Open ^^OPEN CLOSE O STOP 3-Button Control Station Common UL Entrapment Placard Warning Placard SETUP RADIO ANTENNA OPTION A 1 Locate the wire antenna on the outside of the electrical box. Cut the wire tie closest to the edge of the electrical box. Cut this Wire Tie 2 Press the plastic standoff into the hole in the side of the electrical box. Antenna Wire Ties Standoff Cut Wire Tie Antenna 13