LiftMaster TAC2C TAC2C Programming Guide Manual - Page 5

PROGRAMMING » QUICK REFERENCE KEYPAD PROGRAMMING PROGRAMMING NUMBER DESCRIPTION OF TASK FACTORY SETTING PROGRAMMING PROCEDURE 1 Trigger Relay One Master Code (4 digits) + 1 2 Trigger Relay Two 7 Delete User Code 9 Enter User Code Master Code (4 digits) + 2 Master Code (4 digits) + 7 + User Code that is to be deleted (4 digits) Master Code (4 digits) + 9 + New User Code (4 digits) + Relay Associated with the User Code (1 or 2) 03 Enable Intercom (No-Telco) Mode Master Code (4 digits) + 03 04 Enable Telco Mode Enabled Master Code (4 digits) + 04 06 Speaker Volume Level 2 Master Code (4 digits) + 06 + Volume Level (1 = Low, 2 = Medium or 3 = High) 07 Microphone Sensitivity Level 2 Master Code (4 digits) + 07 + Volume Level (1 = Low, 2 = Medium or 3 = High) 09 Change the Master Code Master Code (4 digits) + 09 + ### + New Master Code (4 digits) 51 Create Temporary (1 Shot) Code Master Code (4 digits) + 51 + New Temporary (1 Shot) Code (4 digits) + Relay Associated with the User Code (1 or 2) (Expires after 24 hours) 52 Enable Vacation (Lock Down) Mode Disabled Master Code (4 digits) + 52 53 Disable Vacation (Lock Down) Mode Master Code (4 digits) + 53 54 Engage Party Mode (Relay 1) Disabled Master Code (4 digits) + 54 56 Engage Party Mode (Relay 2) Disabled Master Code (4 digits) + 56 021 Enable Parallel Relay Output Enabled Master Code (4 digits) + 021 023 Enable Independent Relay Output Control Disabled Master Code (4 digits) + 023 024 Adjust Relay Output Time (Relay 1) .5 Seconds Master Code (4 digits) + 024 + Relay Output Time (0000-8000 Seconds) NOTE: Relay output time is ALWAYS 4 digits. 025 Adjust Relay Output Time (Relay 2) .5 Seconds Master Code (4 digits) + 025 + Relay Output Time (0000-8000 Seconds) NOTE: Relay output time is ALWAYS 4 digits. DIRECT COMMANDS FROM THE UNIT KEYPAD KEYSTROKES User Code + 1 User Code + 2 ACTION Triggers Relay 1 Triggers Relay 2 AUDIO FEEDBACK FROM THE UNIT: 1 Low Tone Beep = Failure 2 Two High Tone Beeps = Valid sequence 3 Low Tone Beep = Error or invalid sequence NOTE: Use the STAR Key "*" to cancel any input. NOTE: Keypad commands are to be entered in a single string to result in success (indicated by double high tone). Stop and go keystrokes will result in negative tones (low single and triple fail tones). 5