LiftMaster WGB315 User Guide

LiftMaster WGB315 Manual

Get LiftMaster WGB315 PDF manuals and user guides View all LiftMaster WGB315 manuals
Add to My Manuals
Save this manual to your list of manuals

LiftMaster WGB315 manual content summary:

  • LiftMaster WGB315 | User Guide - Page 1
    RESS TO R ING WIRELESS GATEBELL KEYPAD LEARN MODEL WGB315 315 MHz Security✚® PRESS MODEL WGB315INDR 315 MHz Security✚® TO R ING MODEL WGB315KYPD 315 MHz Security✚® PRESS TO CARTON INVENTORY R ING PRESS TO R ING Keypad* PRESS TO Remote ControRl†ING Drywall Anchors (2)† PRESS TO
  • LiftMaster WGB315 | User Guide - Page 2
    LEARN 3 Push "Press to Ring" on the keypad cover. The gatebell will ring. Press remote control button to open keypad illumination becomes dim or it doesn't stay on after a keystroke. Dispose of old battery properly. FOR SERVICE DIAL OUR TOLL FREE NUMBER: 1-866-826-4943 © 2008, The Chamberlain
  • 1
  • 2
CARTON INVENTORY
TO
PRESS
RING
WIRELESS GATEBELL KEYPAD
MODEL WGB315 315 MHz Security
✚
®
MODEL WGB315INDR 315 MHz Security
✚
®
MODEL WGB315KYPD 315 MHz Security
✚
®
TABLETOP MOUNTING
Keypad*
Remote Control
†
Power Adapter
†
Screws (4)*
†
Receiver
†
1
Insert remote control and power
adapter into receiver. Plug into outlet.
PRESS
RING
TO
3
2
1
4
5
Top Mounting Hole
Bottom
Mounting
Hole
Battery Cover
Battery
Remove battery cover and battery.
Determine location for keypad. Mark
the bottom mounting hole.
Program remote control to the gate
operator radio receiver. Refer to your
gate operator manual for programming
instructions.
Remove foam spacer on underside of
keypad cover
. Check range before
installing. Using two people, hold the
keypad and receiver in the desired locations.
Make sure the keypad rings the gatebell
when pressed. If no chime is heard, repeat
test using a new location for the receiver.
NOTE:
For optimal range performance, mount the receiver to an external wall that is close to the gate operator.
DO NOT MOUNT TO METAL.
For the top mounting screw, mark 4
1/4" (10.8 cm) up the centerline from
the bottom of the keypad. Drill 1/8"
pilot holes for top and bottom screws.
See keypad mounting reference.
Secure keypad with bottom screw, using
care to avoid cracking plastic housing.
Reinstall battery and slide battery cover
up and snap it into place. Close cover.
Install top mounting screw, allowing
1/8" (3.2 mm) to protrude above surface.
Position keypad on screw head and adjust
for snug fit.
KEYPAD MOUNTING
(For reference only)
4 1/4"
(10.8 cm)
Drywall Anchors (2)
†
INSTALLATION • MOUNT KEYPAD
Lift
INSTALLATION • MOUNT RECEIVER
6
*
Keypad and 2 Screws provided in model WGB315KYPD.
†
Remote Control, Receiver, Power Adapter, Drywall Anchors and 2 Screws provided
in model WGB315INDR.