Linksys PCMPC100 User Guide - Page 12

Instant EtherFast® Series 5. Windows will begin searching your drives for the correct device drivers. Once Windows has located the driver, the window below will appear indicating that it located the Linksys EtherFast 10/100 PC Card v3 (PCMPC100 v3). Click Next. ' Note: DO NOT press Skip or Cancel at any time during the installation. Doing so will prevent your driver from being properly installed on your PC. If Windows cannot find the driver for the card, refer to the Troubleshooting section. 6. Windows 98 will begin copying a number of files onto your computer. If Windows asks you to supply your original Windows 98 installation or setup files, insert the CD-ROM or disks as needed, and direct Windows 98 to the proper location, (e.g., C:\windows\options\cabs, D:\win98, or the appropriate drive letter of your CD-ROM drive). If Windows asks you to supply a driver that contains the letters "PC100", type "a:\win98" in the box that pops up. Click OK. During the installation, Windows may ask you for a computer and workgroup name. If so, refer to steps 11-13 in this section. Otherwise, continue with the installation. Windows will finish copying all of the necessary files to your system. Click Finish. EtherFast® 10/100 PC Cards When asked if you want to restart your computer, click No. Once you are back at the Windows 98 desktop, click on the Start button, click Settings, then Control Panel. 7. Double-click on the Network icon. The Network window will appear. Click on the Configuration tab. 8. Make sure that the following network components are installed: Client for Microsoft Networks Linksys EtherFast 10/100 PC Card (PCMPC100 V3) TCP/IP There may be other components listed in addition to the ones shown above. This is fine. However, if any components listed above are missing, you'll need to install them manually. Refer to the Manually Installing the Network Components in Windows 95 and Windows 98 section of the Appendix. Note: If you need to install the TCP/IP Protocol, contact your system administrator or refer to the Windows 98 documentation. Linksys does not provide technical support for the configuration or troubleshooting of the TCP/IP protocol. 9. In the Primary Network Logon box, select Client for Microsoft Networks. 10. To enable File and Printer Sharing, click on the File and Print Sharing button, then put a check mark next to both boxes in the window. Click OK. 18 19