Linksys PCMPC100 User Guide - Page 20

8. Click on the Protocols tab. Add any protocols you require by clicking the Add button. Note: If you install the TCP/IP protocol, refer to your system administrator or your Windows NT documentation when installation steps that aren't listed in this User Guide appear. Linksys does not provide technical support for the configuration or troubleshooting of the TCP/IP protocol. 9. After your bindings, settings, and services are set, click the Close button. Instant EtherFast® Series 10 The Network Settings Change box will appear. Remove your Driver Disk and click theYes button to restart your PC. 11. Once your PC has rebooted, double-click the Network Neighborhood icon on your desktop. Make sure that you have access to the network. If you do, you card has been properly installed. Note: If you had previously installed any NT service packs, you must re-install them. The Windows NT EtherFast Card Installation and Setup is complete. 34 EtherFast® 10/100 PC Cards Windows 2000 Installation and Setup Overview After physically installing the EtherFast PC Card in your computer, follow these instructions to install the network driver. Note: Screen shots used in this Installation and Setup section are from installation of the standard EtherFast 10/100 PC Card (PCMPC100 v3). If you are installing the EtherFast 10/100 Integrated PC Card (PCM100 v3), the installation process will be unchanged, however, the product name will be different. 1. Windows 2000 will automatically recognize your EtherFast PC Card. 2. Windows will then display the Found New Hardware Wizard Screen. Click Next. 35