Linksys RT31P2 User Guide - Page 16
The Front Panel, Power, Ethernet 1-3, Ethernet, Phone 1-2, Phone, Internet - firmware
UPC - 745883559398
View all Linksys RT31P2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Broadband Router with 2 Phone Ports The Front Panel The Router's LEDs, which inform you about network activities, are located on the front panel. Power Ethernet 1-3 Phone 1-2 Internet Figure 3-2: Front Panel Green. The Power LED lights up when the Router is powered on. If the LED is flashing, the Router is booting up, running a system self-test, or upgrading its firmware. Green. The Ethernet LED serves two purposes. If the LED is solidly lit, the Router is connected to a device through the corresponding port (Ethernet 1, 2, or 3). If the LED is flashing, the Router is sending or receiving data over that port. Green. The Phone LED is solidly lit when a telephone or fax machine has a registered connection to Vonage through the corresponding port (Phone 1 or Phone 2). (The connection is registered if your Vonage service account is active.) This LED is not lit when there is no registered connection. It flashes when the phone is being used or an incoming call has been detected. Green. The Internet LED lights up when the Router is connected to your cable or DSL modem. If the LED is flashing, the Router is sending or receiving data over the Internet port. Proceed to "Chapter 4: Connecting the Router." 8 Chapter 3: Connecting the Phone Adapter The Front Panel