Linksys SPA2102-NA Quick Start Guide - Page 1

Before You Begin Make sure you have the following: • An active Internet connection • An active Internet phone service account and its settings • A cable/DSL modem • One computer for configuration of the Phone Adapter • An analog telephone or fax machine with an RJ-11 phone cable 1 Connect the Phone Adapter A Power off your network devices, including your modem and PC. B Connect one end of an RJ-11 phone cable to the Phone Adapter's PHONE 1 Package Contents port. Connect the other end • Phone Adapter with Router • 5 V Power Adapter to your analog telephone or fax machine. B • RJ-45 Ethernet Cable • RJ-11 Phone Cable (not included with all models) IMPORTANT: Do not connect the PHONE port to a telephone wall jack. • Power Adapter Make sure you only connect a • Quick Installation telephone or fax machine to the PHONE port. Otherwise, the Phone Adapter or the telephone wiring in Phone Adapter with Router your home or office may be damaged. C Repeat Step B with the Quick Installation PHONE 2 port if you have an additional telephone or fax Voice machine to connect. ModeMl Nood.el NoS. PA2102 D Connect one end of an Ethernet network cable (included) to the ETHERNET port of the Phone Adapter. Connect the other end to the Ethernet port of your PC. E Connect one end of a different Ethernet network cable to the INTERNET port of the Phone Adapter. Connect the other end to your cable/DSL modem. F Power on the cable/DSL modem. G Connect the included power adapter to the Phone Adapter's power port, and then plug the power adapter into an electrical outlet. The power LED on the front panel will light up as soon as the Phone Adapter powers on. H Power on your PC. D E G NOTE: Make sure your PC's Ethernet adapter is set to obtain an IP address automatically. For more information, refer to Windows Help. 2 Configure the Phone Adapter A Launch the web browser on the PC. B Enter http://192.168.0.1/ advanced in the Address field (192.168.0.1 is the default local IP address of the Phone Adapter). Then press the Enter key. C If your Internet Telephony Service Provider (ITSP) did not supply a password, you will not see a login screen. Proceed to step D. If your ITSP supplied a password, you will see a login screen. In the User Name field, enter user, the default user name for user access (this cannot be changed). Then enter the C password supplied by your ITSP. D The Router - Status screen will appear. Click the WAN Setup tab. D E Proceed to the appropriate instructions for your Internet Connection Type: DHCP, Static IP, or PPPoE. DHCP 1 Select DHCP for the Connection Type. 2 If you use a cable modem, you may need to configure the MAC Clone Settings. (Contact your ISP for more information.) Enable MAC Clone Service. If your service uses a specific PC MAC address, then select yes from the Enable MAC Clone Service setting. Then enter the PC's MAC address in the Cloned MAC Address field. 3 Click Submit All Changes. Static IP 1 Select Static IP for the Connection Type. 2 In the Static IP Settings section, enter the IP address in the Static IP field, the subnet mask in the NetMask field, and the default gateway IP address in the Gateway field. E MAC Clone Settings Static IP