Linksys SRW224P Cisco SRW224P 24-Port 10/100 + 2-Port Gigabit Switch with WebV - Page 89
File Upload, Restore Defaults, Save Config
![]() |
UPC - 745883566068
View all Linksys SRW224P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
24-Port 10/100 + 2-Port Gigabit Switch with Webview and Power over Ethernet File Upload Uploads switch firmware or configuration files to a TFTP server. You must specify the file type to transfer, along with TFTP server IP address and file names as required. Saving firmware and configuration files on a TFTP server enables them to be later downloaded to the switch to restore operation. To Upload a file from the switch select Firmware of Configuration upload using the radio buttons. Enter the IP address of the TFTP server, enter the destination file name and click Apply. Figure 5-71: Maintenance - File Upload Restore Defaults To restore default settings, click the Restore Company Defaults link. Then click OK to proceed or Cancel to cancel. Figure 5-72: Maintenance - Restore Defaults Save Config To save the current configuration settings, click the Save Current Config link. Then click OK to proceed or Cancel to cancel. Chapter 5: Configuring the Switch through the Web Utility Maintenance Figure 5-73: Maintenance - Save Config 81
![](/manual_guide/products/linksys-srw224p-cisco-srw224p-24port-10100-2port-gigabit-switch-webview-power-ethernet-administration-guide-b522a0b/89.png)