Linksys SVIEW04 User Guide - Page 7

ProConnect® Series 3. Connect the monitor, keyboard, and mouse ports of your PC(s), up to 64, to a CPU port in one the Tertiary units with a Cabling Kit. 4. Plug the Power Adapters into the 4-Station CPU Switches' power ports, then plug each Power Adapter into a power source. 5. Power on the connected PC(s). 8 ProConnect® 4-Station CPU Switch Using the ProConnect® 4-Station CPU Switch Hot Plugging The 4-Station CPU Switch supports hot plugging - cables can be connected or unplugged without turning off the switch's power. In order for hot plugging to work properly, however, these procedures must be followed: • Hot Plugging CPU Ports CPU port cables can be unplugged if necessary without powering down the switch. If you reconnect the Cabling Kit (available from your nearest Linksys dealer) to the same port on the switch, the switch will immediately recognize the PC. If you connect it to a different CPU port, the switch will need to redetect and initialize the connection. • Hot Plugging Console Ports The switch supports limited hot plugging of the keyboard, monitor, and mouse. Keyboards and monitors can be hot plugged on the Console ports. When hot plugging the mouse from the Console's mouse port, however, the following should be considered: 1. You may unplug the mouse and plug it back in again (to reset the mouse, for example), as long as you use the exact same mouse. 2. If you plug in a different mouse, all of the switches and all the PCs connected to the switches must be shut down and restarted. (Refer to the Powering Off and Restarting section the follows.) NOTE: If there is no response to mouse and/or keyboard input, simultaneously press and hold Port Selection buttons 1 and 2 on the Primary 4-Station CPU Switch for about ten seconds to reset the keyboard and mouse connection. 9