Logitech K700 User's Guide - Page 6

Logitech® Keyboard Controller Help with setup Problem: My Keyboard Controller does not work or will not connect. Solution: Check the following: • Is the Keyboard Controller on? The ON/OFF power switch must be set to ON. If it is, turn the power switch OFF and then ON. The power LED above the Touchpad should light green, or red if the batteries are low in power. • Are the batteries installed properly? Remove the battery cover and check battery installation. Refer to page 9 for more information. • Is your Keyboard Controller paired with the Logitech Revue™ Companion Box (sold separately)? To pair the Companion Box with the Keyboard Controller, turn on the Keyboard Controller. Press and release the button located on the back of the Logitech Revue Companion Box under the Unifying logo. Now, turn the keyboard power switch OFF and then ON. Refer to page 7 for more information. • Is your Keyboard Controller paired with a Google TV - based smart TV system? Make sure the Unifying receiver is plugged into a USB port on your Google TV. Try using the USB cable extender to place the Unifying receiver farther away from your TV, which may be producing electromagnetic interference. Refer to page 6 for more information. You may need to reestablish the connection between the Keyboard Controller and its Unifying receiver: 1. Insert the Unifying receiver in a USB port on a PC that is connected to the Internet. 2. Download the Unifying software from www.logitech.com/unifying. 3. Follow the on-screen instructions to reconnect the Keyboard Controller with the Unifying receiver. 4. When finished, insert the Unifying receiver back into a USB port on the TV. The connection between the Keyboard Controller and Unifying receiver should now be re-established. 10 Logitech® Keyboard Controller Problem: In a Logitech Revue™ setup, my TV, STB (set-top box), or AVR (audio-video receiver) is not responding to the Keyboard Controller. Solution: Check the following: • Is the device IR controlled? Some home theater devices are controlled by line-of-sight, infrared communication (IR), and others are controlled by high-frequency radio waves (RF). If you are using the Logitech Revue Companion Box, this device only controls IR-enabled TVs, STBs, and AVRs, and will not communicate with RF-controlled components. • Is the IR signal blocked? Use the mini blaster (which comes with your Logitech Revue Companion Box) to extend the range of the Companion Box IR signal. • Is the mini blaster close enough to have a direct line of sight with your device? Try moving the mini blaster closer to the device. • Is the device still not responding? You may need to teach additional IR commands to your Logitech Revue Companion Box. Launch the "Logitech Help and More" application from Logitech Revue to find the video, "Teaching Infrared commands to your Revue." Problem: How do I enable or disable the tap-to-select feature on the Touchpad? Solution: If you prefer to tap on the Touchpad instead of clicking, you can enable this gesture by pressing the Left Ctrl + FN + Ch/Pg Up keys simultaneously. To disable this feature, press the Left Ctrl + FN + Ch/Pg Down keys simultaneously. What do you think? Please take a minute to tell us. Thank you for purchasing our product. www.logitech.com/ithink 11