Mackie 406M Owner's Manual - Page 12

808S with External Mixer using PPM Amplifiers 12 From MONITOR OUT Drum Horn Mics Mics Monitor Send From MIXER OUT Stereo Line Mic Mon Mixer Aux Inputs Inputs Out Line Return Outs Submixer (closely resembling a Mackie CR1604-VLZ) To POWER AMP IN POWER AMP ROUTING Button OUT Left FOH Speakers From LEFT SPEAKER OUT OO OO OO OO OO U 1 MON U 2 MON U 3 MON U 4 MON U 5 MON U 6 MON U 7 MON U 8 MON CUSTOM 32-BIT PRECISION DIGITAL STEREO EFFECTS PROCESSING OO OO +15 U EFX +10 U -15 +15 U HI 12kHz -12 +12 U MID 2.5kHz -15 +15 LOW 80Hz PAN OO OO +15 U EFX +10 U -15 +15 U HI 12kHz -12 +12 U MID 2.5kHz -15 +15 LOW 80Hz PAN OO OO +15 U EFX +10 U -15 +15 U HI 12kHz -12 +12 U MID 2.5kHz -15 +15 LOW 80Hz PAN OO OO +15 U EFX +10 U -15 +15 U HI 12kHz -12 +12 U MID 2.5kHz -15 +15 LOW 80Hz PAN OO OO +15 U EFX +10 U -15 +15 U HI 12kHz -12 +12 U MID 2.5kHz -15 +15 LOW 80Hz PAN OO OO +15 U EFX +10 U -15 +15 U HI 12kHz -12 +12 U MID 2.5kHz -15 +15 LOW 80Hz PAN OO OO +15 U EFX +10 U -15 +15 U HI 12kHz -12 +12 U MID 2.5kHz -15 +15 LOW 80Hz PAN OO OO +15 U NORMAL EFX +10 U -15 +15 U -12 +12 U -15 +15 HI 12kHz 0 12 EFX DRIVE LEVEL EFX CLIP MID 2.5kHz LOW 80Hz REVERSE GATED CATHEDRAL LG. HALL MD. HALL LG. PLATE MD. PLATE SM. ROOM EFX BYPASS EFX WIDE DELAY 1 DELAY 2 DELAY 3 DELAY 4 CHORUS FLANGE PHASER SPRING PARAMETERS PAN NORMAL NORMAL L R NORMAL INPUT LEVEL SET L R NORMAL INPUT LEVEL SET L R NORMAL INPUT LEVEL SET L R NORMAL INPUT LEVEL SET L R NORMAL INPUT LEVEL SET L R NORMAL INPUT LEVEL SET L R NORMAL INPUT LEVEL SET L R NORMAL INPUT LEVEL SET LOW HI U LOW HI U LOW HI U LOW HI U LOW HI U LOW HI U LOW HI U LOW HI U 0 10 TIME RATE REVERBS DELAYS CHORUS FLANGE PHASER 0 10 DAMPING DEPTH OO +20dB 1 VOLUME CH. OO +20dB 2 VOLUME CH. OO +20dB 3 VOLUME CH. OO +20dB 4 VOLUME CH. OO +20dB 5 VOLUME CH. OO +20dB 6 VOLUME CH. OO +20dB 7 VOLUME CH. OO +20dB 8 VOLUME CH. PHANTOM POWER CH 1-8 BREAK (MUTES CH 1-6) POWER MASTER OUTPUT SECTION 63 125 250 500 1K 2K 4K 8K 16K U +15 15+ 10 10 +10 5 5 EFX TO MON 0 0 U 5 5 10 10 -15 15- +12dB 75Hz RUMBLE REDUCTION MONITOR EQUALIZER MONITOR MASTER LEVEL CLIP 5 0 5 10 15 20 30 63 125 250 500 1K 2K 4K 8K 16K U +15 15+ 10 10 +10 5 5 EFX TO MAIN 0 0 U 5 5 10 10 -15 15- +12dB MAIN-STEREO/MONO EQUALIZER 75Hz RUMBLE REDUCTION MAIN MASTER LEVEL CLIP 5 0 5 10 15 20 30 LR INSERT LINE MIC 1 INSERT LINE MIC 2 INSERT LINE MIC 3 INSERT LINE MIC 4 INSERT LINE MIC 5 INSERT LEFT/MONO LEFT/MONO LINE STEREO MIC/ LINE HI-Z RIGHT STEREO MIC/ LINE HI-Z RIGHT MIC 6 MIC 7 MIC 8 POWER AMP ROUTING STEREO MAINS LEFT = MAIN RIGHT = MONITOR EFFECTS (OVERRIDES INTERNAL EFX) EFX FOOT SWITCH SEND LEFT RETURN RIGHT RETURN 808S 2 X 400W STEREO PROFESSIONAL POWERED MIXER L POWER AMP IN MAINS R POWER AMP IN MONITOR LINE OUT L MIXER OUT R MIXER OUT COMPRESSOR OUT IN TAPE IN U L R +15 LEVEL L R TAPE OUT From MONITOR OUT From MIXER OUT Stereo Processor Direct Box Processor Vocal Mics Monitor Amplifier Monitor Speakers From RIGHT SPEAKER OUT Right FOH Speakers If you need more inputs than those provided by your PPM Series Powered Mixer, this setup shows how to use an external submixer to add additional inputs into the mix. The MIXER LINE OUT(s) from the powered mixer are routed to two mono or a stereo aux return on the submixer, where the signal is mixed with the additional inputs connected to the submixer. The final, overall mix is routed back to the POWER AMP IN jacks on the powered mixer, which powers the main FOH speakers. Route the MONITOR LINE OUT on the powered mixer to an unused line input on the submixer. Leave that channel's volume control turned down, and set the channel's monitor send control to unity gain. The monitor out on the submixer is routed to an external power amplifier, which drives the monitor speakers. Note: Since each amplifier is driving two speakers in parallel, each speaker must be 4 ohms or greater.