Mackie Onyx 1220 Owner's Manual - Page 21

Owner's Manual Appendix A: Service Information Warranty Service Details concerning Warranty Service are spelled out in the Warranty section on page 31. If you think your Onyx mixer has a problem, please do everything you can to confirm it before calling for service. Doing so might save you from the deprivation of your Onyx mixer and the associated suffering. These may sound obvious to you, but here are some things you can check. Read on. Troubleshooting No Power • Our favorite question: Is it plugged in? • Make sure the power cord is securely seated in the IEC socket (44) and plugged all the way into the AC outlet. • Is there something plugged into the CHANNEL INSERT jack (50)? Try unplugging any INSERT devices (channels 1-4 only). • Try the same source signal in another channel, set up exactly like the suspect channel. Bad Output • Is the associated level control (if any) turned up? • If it's one of the MAIN OUTPUTS, try unplugging all the others. For example, if it's the 1/4" LEFT MAIN OUT, unplug the RCA LEFT TAPE OUT and XLR LEFT OUTPUT. If the problem goes away, it's not the mixer. • If it's a stereo pair, try switching them around. For example, if a left output is presumed dead, switch the left and right cords at the mixer end. If the problem stays on the left side, it's not the mixer. • Make sure the AC outlet is live (check with a tester or lamp). • Is the POWER (43) switch on? Make sure the POWER switch on the rear panel is in the ON position (up). • Is the POWER LED (37) on the front panel illuminated? If not, make sure the AC outlet is live. If so, refer to "No Sound" below. • Are all the lights out in your building? If so, contact your local power company to get power restored. • If the POWER LED is not illuminated, and you are certain that the AC outlet is live, it will be necessary to have your Onyx 1220 serviced. There are no user serviceable parts inside. Refer to "Repair" at the end of this section to find out how to proceed. Bad Channel • Is the MUTE/ALT 3-4 switch (16) in the correct position? • Is the input GAIN control (7) for the channel turned up? Bad Sound • Is the input connector plugged completely into the jack? • Is it loud and distorted? Make sure the input GAIN control for the input is set correctly. Reduce the signal level on the input source if possible. • If possible, listen to the signal with headphones plugged into the input source device. If it sounds bad there, it's not the Onyx causing the problem. Noise/Hum • Turn down the AUX RETURN knobs (28). If the noise disappears, it's coming from whatever is plugged into the AUX RETURNS (39). • Turn down each channel, one by one. If the noise disappears, it's coming from whatever is plugged into that channel. • Check the signal cables between the input sources and the Onyx. Disconnect them one by one. When the noise goes away, you'll know which input source is causing the problem. • Is the fader (17) turned up? • Is the signal source turned up? Make sure the signal level from the selected input source is high enough to light up some of the INPUT meter (18) LEDs next to the channel's fader. • Sometimes it helps to plug all the audio equipment into the same AC circuit so they share a common ground. • If it is channel 1 or 2, make sure the MIC/HI-Z switch (4) is in the right position. Owner's Manual 21