Mackie S225 Owner's Manual - Page 9
S225 Specifications, Care And Maintenance - watts
View all Mackie S225 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
CARE AND MAINTENANCE • Avoid exposure to extreme cold (below freezing temperatures). If you must operate the loud- Your Mackie loudspeakers will provide many years of reliable service if you follow these guidelines: speakers in a cold environment, warm up the voice coils slowly by sending a low-level signal through them for about 15 minutes prior to high-power Avoid exposing the loudspeakers to operation. moisture. If they are set up outdoors, be sure they are under cover if you • Use a slighty damp cloth with a mild soap solution expect rain. to clean the cabinets. Only do this when the power is turned off. Avoid getting moisture into any of the openings of the cabinet, particularly where the driv- ers are located. S225 SPECIFICATIONS Acoustic Performance Frequency Range (-10 dB) 46 Hz-20 kHz Frequency Response (-3 dB) 70 Hz-18 kHz Horizonal Coverage Angle (-6 dB) 90º averaged 2 kHz to 10 kHz Vertical Coverage Angle (-6 dB) 40º averaged 2 kHz to 10 kHz Directivity Factor; DI (Q) 11.9 (15.6) averaged 2k Hz to 10 kHz Sensitivity (1W/1m) 102 dB SPL Max SPL long-term 132 dB @ 1m Max SPL peak 135 dB @ 1m Crossover Point 1300 Hz Input/Output Input/Output Type Neutrik Speakon™ and female 1/4-in. TS jack Input Impedance 4 ohms Recommended Amplifier Power 700 watts rms continuous 2800 watts peak Physical Properties Height 50.0 in/127.0 cm Front Width 19.1 in/48.5 cm Rear Width 13.9 in/35.3 cm Depth 18.1 in/46.0 cm Weight 99.5 lb/45.1 kg Mounting Methods Floor mount only. The S225 should never be pole-mounted. The S225 cabinet has no rigging points and is not suitable for flying. Never attempt to suspend the cabinet by its handles. Disclaimer Since we are always striving to make our products better by incorporating new and improved materials, components, and manufacturing methods, we reserve the right to change these specifications at any time without notice. "Mackie" and the "Running Man" figure are registered trademarks of LOUD Technologies Inc. All other brand names mentioned are trademarks or registered trademarks of their respective holders, and are hereby acknowledged. High-Frequency Section Voice Coil Diameter 1.75 in/44 mm Horn Exit Diameter 1.0 in/25 mm Phase Plug Optimized geometry Diaphragm Material Titanium Magnet Material Ferrite Low-Frequency Section Number of Drivers 2 Woofer Diameter 15.0 in/381 mm Voice Coil Diameter 2.5 in/63 mm Diaphragm Material Epoxy-reinforced cellulose Magnet Material Ferrite Safety Features Input Protection Dynamic protection for compression driver Need Help? You can reach a technical support representative Monday through Friday from 7 AM to 5 PM PST at: 1-800-898-3211 After hours, visit www.mackie.com and click Support, or email us at: [email protected] Construction Features Basic Design Trapezoidal, 10º side angles Material 18 mm multi-layered plywood, resin end caps Finish Wear-resistant textured black Handles Grille PVC vinyl One on each side, one top, one bottom Perforated metal with weather- ©2004-2005 LOUD Technologies Inc. All Rights Reserved. resistant coating 9