Macrom M-TVT300D User Manual (English) - Page 10

1.You can move the cursor to"area search" via press"CH+/-" key under "installation menu" ,then press"enter" to enter into area searching page. 2.Prior manual scanning, you need to configure relevant parameters including: (1).Freq(KHz): the default frequency is 474000KHz, you can input relevant digital to modify it.; (2).Band Width: the default value of bandwidth is 8 MHz. while you can set it to 6 MHz, 7 MHz, 8 Mhz.; 3.Press"OK"key after configuration of start manual scan. 4.If any program is detected and the scanning process is finished, system will exit the scanning page and save the program, at the same time return to the"instal lation menu" and to play them automatically. As shown in the figure below: 2.1.3 Auto Search You can search the programs of any channel. 1.You can move the cursor to"area search" to enter into area searching page, As shown in figure below: Figure 4.7 auto search menu 2.Prior to auto scanning, you need to configure relevant parameters including: (1).Start Freq(KHz):the default frequency is 474000KHz, you can input relevant digital to modify it.; (2).End Freq(KHz):the default frequency is 474000KHz. While you can input relevant digital to modify it; (3).Band Width: the default value of bandwidth is 8 MHz. while you can set it to 6 MHz, 7 MHz, 8MHz .; 3.Press"OK"key after configuration of parameters to start manual scan. 4.If any program is detected and the scanning process is finished, system will exit the scanning page and save the program, at the same time return to the "installation menu" and to play them automatically. As shown in the figure below. 2.2 CHANNEL MANAGER System offer an efficient function of channel management such as channel deleting, marking, moving, locking, sorting and grouping. There are two independent pages for channel management, TV and RADIO. You can enter the page via"digital TV channel manager" as shown in the figure below: 9