Magic Chef MCSDRY35W User Manual - Page 11

Install the four (4) wood screws to the 5 bottom wooden slat. Install the exhaust connector as shown in the illustration using the (3) ½" Phillips round head screws included. 6 • For downward exhaust, refer to Section 1. • For upward exhaust, refer to Section 2. Section 1 Wood Screws Exhaust Connector Section 2 Install the lower wall spacers (included) using the (2) ½" Phillips flat head screws (included). These spacers are required when installing the unit on the wall to allow the necessary 7 ventilation for efficient operation. Failure to install the spacers will both reduce the ventilation needed to operate your unit as well as put the appliance in a tilted position on the wall which could present a possible unstable wall installation. Mount the dryer to the wall hanging assembly. With the assistance of a 2nd person, lift the dryer and align the mounting holes at the rear of the dryer with the mounting hooks. Tilting the dryer to a 45° angle, insert the 8 hanging brackets into the mounting holes on the dryer as shown in the figure to the right. Once the dryer mounts are in place, slowly lower the dryer in place and check all installation points for stress or weakened contact. 11 Wall Spacers ½" Phillips Flat Head Screws