Magic Chef MCWBC24DZ1 User Manual - Page 7

7 Freestanding Installation • This appliance is designed to be built-in or freestanding. • Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Ambient temperature below 68oF (20oC) or above 90oF (32oC) will hinder the performance of this appliance. This unit is not designed for use in a garage or any other outside installation. • Avoid locating the appliance in moist areas. • Plug the appliance into a dedicated, properly installed grounded wall outlet. This appliance should be operated on a separate electrical circuit from other operating appliances. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorized service center. This unit is not designed to be installed in an RV or used with an inverter. • After plugging the appliance into a wall outlet, allow the unit to cool down for approximately 3-4 hours before placing wine bottles or beverage cans in the appliance. Built-In Installation The cutout dimensions illustrated in Figure A allow the door to swing open and also allow access to the pull-out shelves. If you are installing the unit between frameless cabinets, a ½" wide filler strip or side panel may be needed on the hinge side. The filler strip will act as a spacer between the appliance case and the adjacent cabinet door swing. The width of the opening must include the filler panels. Note: The door should protrude at least 1" beyond the surrounding cabinets. Figure A - The cutout depth must be 24" EN - 7