Magnavox 32MD359B User Manual - Page 6
Attaching the Stand, Supplied Accessories - remote control
UPC - 609585163997
View all Magnavox 32MD359B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
INTRODUCTION 5 Supplied Accessories user manual (1EMN24199) quick start guide (1EMN24379) remote control (NF801UD) registration card (1EMN24699) Phillips pan screw for attaching the stand x 4 (FPH34200) batteries (AAA x 2) AAA AAA • If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free customer support line found on the cover of this manual. 5 Attaching the Stand You must attach the stand to the unit to display upright. Be sure the front and rear of the stand match the proper direction. 1 2 Spread a thick and soft cloth over a Hang the hook under the bottom table. of the main unit to the stand's hole 3 Drive Phillips pan screws in the 4 threaded holes at the bottom of the Place the main unit face down onto it. (shown arrow ➀), then slide down the stand with a screwdriver tightly. Make sure not to damage the screen. stand in the direction of the screen At least two people are required at (shown arrow ➁). this step. Make sure not to put the AC power cord between the stand and the unit. screw holes front side To remove the stand from this unit Unscrew the Phillips pan screws indicated by "➂". Pull up the stand in the direction of the rear of the unit. Be careful not to drop the stand when you remove it. Note: • When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall, resulting in injuries as well as damage to the unit. • Make sure to use a table which can support the weight of this unit and is larger than this unit. • Make sure the table is in a stable location. 6 EN