Magnavox 42MF237S User manual, English (US) - Page 13
First time installation - manual
View all Magnavox 42MF237S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
English Française Español First time installation Note: The first time (and only the first time) you turn on your set you see an installation introduction screen. The Installation procedure consists of a series of screens that guide you through the process. & After an introduction screen, you are asked to select a language of the TV's on-screen-menus. (The text of the header and the info on screen continuously change language.) é Press the cursor up/down to highlight your language. " Press the OK button. ' Follow the on-screen instructions to proceed. Part 1: TV installation (Please skip this section if you have no cable connected to the Antenna input of the TV.) Note - The TV will take approximately 10-15 seconds to start up. & Select the desired Language and press the green button "Next". é Select Cable or Antenna in the Installation mode and press the green button "Next". " Auto Installation may take 20 to 40 minutes depending on the number of channels that are transmitted by the cable provider or broadcaster. ' When the TV is not receiving any signal from the antenna/cable, the message CHANNEL NOT AVAILABLE will appear on the TV screen. When no transmission is received from the broadcaster, a BLANK SCREEN will appear on the TV screen. Note - The TV will go on to standby after 10 minutes. Press the POWER button on the remote control to on the TV. ( You will not be able to receive pay channels when using direct antenna/cable connection to the television. § When the Set-top box is connected to the television using coaxial cable, it is necessary to auto-program the television for the single channel (3 or 4) that the Set-top box outputs and change the channels at the Set-top Box (using the set-top remote control) to view the program. Refer to the manual for more details. Note - The newly installed channels maybe sorted in a different sequence on this TV. Please key using the CH +/- buttons to get to know the new channel. Also you can use the OK key to see the list of channels. è When the Set-top box is connected to the television using one of the AV connections (AV 1/ AV 2/ HDMI 1/ HDMI 2), select that input source (using the AV button) to view the programs and change the channels at the Set-top Box (using the set-top box remote control) to view the program. 5