Magnavox 42MF439B User Manual - Page 5

INTRODUCTION PREPARATION WATCHING TV OPTIONAL SETTING TROUBLESHOOTING INFORMATION 5 Trademark Information • HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC. • Manufactured under license from Dolby Laboratories. "Dolby" and the double-D symbol are trademarks of Dolby Laboratories. • Products that have earned ENERGY STAR® are designed to protect the environment through superior energy efficiency. 5 Supplied Accessories user manual (1EMN24661) quick start guide (1EMN24665) remote control (NF802UD) registration card (1EMN24699) Phillips pan screw for attaching the stand x 4 (FPH34140) batteries (AAA x 2) A AAA cable management tie (1EM428657) AC power cord (WAV0162LW001) or (WAV0162LTE03) • If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free customer support line found on the cover of this manual. 5 Attaching the Stand You must attach the stand to the unit to have it as a table top unit. Be sure the front and rear of the stand match the proper direction. 1 2 Spread a thick and soft cloth over a Insert the neck under the bottom table as shown below. of the main unit to the stand's hole Place the main unit face down onto it. (shown by arrow ➀). Make sure not to damage the screen. At least two people are required at this step. 3 Drive Phillips pan screws in the 4 threaded holes at the bottom of the stand until they are tight.  screw holes Œ front side To remove the stand from this unit Unscrew the Phillips pan screws indicated by above "➁"screw holes. After the screws are removed pull the stand up toward the rear of the unit. Be careful not to drop the stand when you remove it. Note: • When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall, resulting in injuries as well as damage to the unit. • Make sure to use a table which can support the weight of this unit and is larger than this unit. • Make sure the table is in a stable location. 5 Symbols Used in this Manual The following is the description for the symbols used in this manual. Description refers to: TV : Analog TV operation DTV : Digital TV operation • If neither symbol appears under the function heading, operation is applicable to both. 5 EN