Makita 2414DB Owners Manual - Page 9
the holes in the guide plate.
View all Makita 2414DB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
003764 When the cut-off wheel has worn down considerably, use a spacer block of sturdy, non-flammable material behind the 1 workpiece as shown in the figure. You can more efficiently utilize the worn wheel by using the mid point on the periphery of the wheel to cut the workpiece. 1. Spacer block 1 2 3 5 4 003765 When cutting workpieces over 65 mm (2-9/16") wide at an angle, attach a straight piece of wood (spacer) over 190 mm (7-1/2") long x 45 mm (1-3/4") wide to the guide plate as shown in the figure. Attach this spacer with screws through the holes in the guide plate. 1. Guide plate 2. Straight piece of wood (Spacer) 3. Over 45 mm (1-3/4") long 4. Over 65 mm (2-9/16") long 5. Over 190 mm (7-1/2") long 003766 1 2 3 If you use a spacer block which is slightly narrower than the workpiece as shown in the figure, you can also utilize the wheel economically. 5 4 1. Diameter of workpiece 2. Guide plate 3. Spacer block 4. Width of spacer block 5. Vise 003767 1 Long workpieces must be supported by blocks of non-flammable material on either side so that it will be level with the base top. 1. Blocks 9