Makita 4114 Owners Manual - Page 4
Save These Instructions, Symbols, Functional Description - case
View all Makita 4114 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
6. Use only flanges specified for this tool. 7. Be careful not to damage the spindle or the flange (especially the installing surface). Damage to these parts could result in wheel breakage. 8. NEVER use tool with wood cutting blades or other sawblades. Such blades when used on a grinder frequently kick and cause loss of control leading to personal injury. 9. Hold the tool firmly. 10. Keep hands away from rotating parts. 11. Make sure cord is clear of wheel. Do not wrap cord around your arm or wrist. If control of tool is lost, cord may become wrapped around you and cause personal injury. 12. Make sure the wheel is not contacting the workpiece before the switch is turned on. 13. Before using the tool on an actual workpiece, let it run for a while. Watch for vibration or wobbling that could indicate poor installation or a poorly balanced wheel. 14. Watch out for flying sparks. Hold the tool so that sparks fly away from you and other persons or flammable materials. 15. Do not leave the tool running. Operate the tool only when hand-held. 16. Do not touch the workpiece immediately after operation; it may be extremely hot and could burn your skin. 17. ALWAYS wear proper apparel including long sleeve shirts, leather gloves and shop aprons to protect skin from contact with hot cuttings. 18. Use of this tool to cut some products could expose user to dust containing hazardous substances. Use appropriate respiratory protection. 19. The tool must be used only for dry cutting. DO NOT use water. SAVE THESE INSTRUCTIONS WARNING: MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. SYMBOLS USD291-2 The followings show the symbols used for tool. V volts A amperes alternating or direct current no load speed Class II Construction .../min revolutions or reciprocation per minute FUNCTIONAL DESCRIPTION CAUTION: • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Adjusting the depth of cut 004377 1 1. Wing bolt 2. Base 3. Cutting depth 3 2 Loosen the wing bolt on the depth guide and move the base up or down. At the desired depth of cut, secure the base by tightening the wing bolt. Only case you adjust the cutting depth to the maximum one, always be sure to do the adjustment after adjustment of the wheel guard. Securing wheel guard 004014 1. Clamping nut 1 2. Wheel guard 2 CAUTION: • The wheel guard must be adjusted on the tool so that the closed side of the guard always points toward the operator. The wheel guard can be adjusted about 80 degrees, after you loosen the clamping nut. Adjust to the desired angle, then secure the clamping nut. 4