Makita 6349DWDE Owners Manual - Page 6
Assembly
View all Makita 6349DWDE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
NOTE: • When changing the position from " " to " ", it may be a little difficult to slide the mode change lever. At this time, switch on and run the tool for a second at the " " position, then stop the tool and slide to your desired position. CAUTION: • Always slide the action mode change lever all the way to your desired mode position. If you operate the tool with the lever positioned halfway between the mode symbols, the tool may be damaged. • Do not use the action mode change lever while the tool is running. The tool may be damaged. Adjusting the fastening torque 006265 1. Arrow 2. Adjusting ring 3. Graduations 2 1 3 Installing side grip (auxiliary handle) 006266 1 5 1. Steel band 2. Grip base 3. Side grip 2 4. Protrusion 4 5. Groove 3 Always use the side grip to ensure operating safety. Insert the side grip so that the protrusions on the grip base fit in between the grooves on the tool barrel. Then tighten the grip by turning clockwise. Installing or removing driver bit or drill bit 006267 1. Sleeve 1 The fastening torque can be adjusted in 16 steps by turning the adjusting ring so that its graduations are aligned with the pointer on the tool body. First, slide the action mode change lever to the position of symbol. The fastening torque is minimum when the number 1 is aligned with the pointer, and maximum when the marking is aligned with the pointer. The clutch will slip at various torque levels when set at the number 1 to 16. Before actual operation, drive a trial screw into your material or a piece of duplicate material to determine which torque level is required for a particular application. NOTE: • The adjusting ring does not lock when the pointer is positioned only halfway between the graduations. Turn the sleeve counterclockwise to open the chuck jaws. Place the bit in the chuck as far as it will go. Turn the sleeve clockwise to tighten the chuck. To remove the bit, turn the sleeve counterclockwise. When not using the driver bit, keep it in the bit holders. Bits 45 mm (1-3/4") long can be kept there. 001900 1. Bit 2. Bit holder 1 2 ASSEMBLY CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Adjustable depth rod (Optional accessory) 006268 1. Depth rod 2. Clamp screw 1 2 6