Makita 6349DWDE Owners Manual - Page 7

The adjustable depth rod is used to drill holes of uniform depth. Loosen the clamp screw, set to desired position, then tighten the clamp screw. Hook The hook is convenient for temporarily hanging the tool. This can be removed without using a tool. This can be installed on either side of the tool. 90 Installing and removing hook A) Removal Remove the battery cartridge from the tool. Place the tool in a stable and level surface. Expand an far end of the hook outward and slide it down while expanding. 006275 006277 006278 Expand the other far end in the same manner. 006276 B) Installation Remove the battery cartridge from the tool. Place the tool in a stable and level surface. Hold both hooking ends in the upper position and expand the upper part of the hook. 006279 1. Hooking ends 1 Keeping the hook in this position, rotate down to the angle 90°and remove it by pulling in the direction of arrow as shown in the figure. 006274 Insert both ends, one by one, of the hook into the grooves in the tool housing. 006280 1 1. Groove in the housing 7