Makita 9558HP Instruction Manual - Page 7
Installing or removing flex wheel
View all Makita 9558HP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
1 1 2 3 2 ► 1 . Wheel guard 2. Bearing box 3. Screw CAUTION: • When using a depressed center grinding wheel/ Multi-disc, flex wheel, wire wheel brush, cut-off wheel or diamond wheel, the wheel guard must be fitted on the tool so that the closed side of the guard always points toward the operator. Mount the wheel guard with the protrusion on the wheel guard band aligned with the notch on the bearing box. Then rotate the wheel guard around 180 degrees. Be sure to tighten the screw securely. To remove wheel guard, follow the installation procedure in reverse. Installing or removing depressed center grinding wheel/Multi-disc ► 1 . Lock nut wrench 2. Shaft lock To remove the wheel, follow the installation procedure in reverse. WARNING: • Only actuate the shaft lock when the spindle is not moving. Installing or removing flex wheel (optional accessory) 1 2 3 1 4 2 3 ► 1 . Lock nut 2. Depressed center wheel/Multi-disc 3. Inner flange WARNING: • Always use supplied guard when depressed center grinding wheel/Multi-disc is on tool. Wheel can shatter during use and guard helps to reduce chances of personal injury. Mount the inner flange onto the spindle. Fit the wheel/ disc on the inner flange and screw the lock nut onto the spindle. To tighten the lock nut, press the shaft lock firmly so that the spindle cannot revolve, then use the lock nut wrench and securely tighten clockwise. ► 1 . Lock nut 2. Flex wheel 3. Back up pad 4. Inner flange WARNING: • Always use supplied guard when flex wheel is on tool. Wheel can scatter during use and guard helps to reduce chances of personal injury. Follow instructions for depressed center grinding wheel/ Multi-disc but also use back up pad over wheel. See order of assembly on accessories page in this manual. 7 ENGLISH