Makita AF506 AF506 Instruction Manual - Page 4
Parts Description, Installation - nails
View all Makita AF506 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Symbols The followings show the symbols used for tool. Read and understand tool labels and manual. Failure to follow warnings could result in death or serious injury. Operators and others in work area must wear safety glasses with side shields. Keep fingers away from trigger when not driving fasteners to avoid accidental discharge. PARTS DESCRIPTION 1 2 4 3 ► 1 . Trigger 2. Hook 3. Nose adapter (contact ele- ment) 4. Magazine INSTALLATION Selecting compressor 2.5 3 2 4 2 1.5 5 1 0.5 0 10 20 30 40 50 60 1 1. Nailing frequency (times/min) 2. Compressor air output per minute (CFM (ft3 /min.)) 3. 0.83 MPa (120 PSIG) 4. 0.74 MPa (105 PSIG) 5. 0.64 MPa (90 PSIG) The air compressor must comply with the requirements of ANSI B19.3. Select a compressor that has ample pressure and air output to assure cost-efficient operation. The graph shows the relation between nailing frequency, applicable pressure and compressor air output. Thus, for example, if nailing takes place at a rate of approximately 60 times per minute at a compression of 0.64 MPa (90 PSIG), a compressor with an air output over 1.5 CFM ( ft3/minute) is required. Pressure regulators must be used to limit air pressure to the rated pressure of the tool where air supply pressure exceeds the tool's rated pressure. Failure to do so may result in serious injury to tool operator or persons in the vicinity. Selecting air hose CAUTION: Low air output of the compressor, or a long or smaller diameter air hose in relation to the nailing frequency may cause a decrease in the driving capability of the tool. 4 ENGLISH