Makita BTD141 Owners Manual - Page 6

Reversing switch action 1. Reversing 1 switch lever 1. Bit 2. Sleeve A 1 B 006248 This tool has a reversing switch to change the direction of rotation. Depress the reversing switch lever from the A side for clockwise rotation or from the B side for counterclockwise rotation. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. 2 006249 For Model BTD141 To install the bit, insert the bit into the sleeve as far as it will go. 1. Bit 1 2. Sleeve CAUTION: • Always check the direction of rotation before operation. • Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. • When not operating the tool, always set the reversing switch lever to the neutral position. ASSEMBLY CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Installing or removing driver bit or socket bit 12 mm (15/32") 9 mm (3/8") 2 008433 To remove the bit, pull the sleeve in the direction of the arrow and pull the bit out firmly. NOTE: • If the bit is not inserted deep enough into the sleeve, the sleeve will not return to its original position and the bit will not be secured. In this case, try re-inserting the bit according to the instructions above. • When it is difficult to insert the bit, pull the sleeve and insert it into the sleeve as for as it will go. • After inserting the bit, make sure that it is firmly secured. If it comes out, do not use it. Hook 1. Hook 2. Screw 3 3. Groove 2 001266 Use only the driver bit or socket bit shown in the figure. Do not use any other driver bit or socket bit. For Models BTD130F,BTD140 To install the bit, pull the sleeve in the direction of the arrow and insert the bit into the sleeve as far as it will go. Then release the sleeve to secure the bit. 1 007521 The hook is convenient for temporarily hanging the tool. This can be installed on either side of the tool. To install the hook, insert it into a groove in the tool housing on either side and then secure it with a screw. To remove, loosen the screw and then take it out. 6