Makita DA4000LR Owners Manual - Page 9

003068 Remove the chuck remaining bolt through the chuck opening by turning it counterclockwise with the hex wrench. CAUTION: 1 • The drill chuck and the bolt are assembled each other. Turn the bolt counterclockwise about 10 times so that they can be removed together. 1. Hex wrench 1 2 003069 Loosen the bolts of the joint by the hex wrench and remove the angle housing, the joint and the socket. 3 4 1. Angle housing 2. Joint 3. Socket 4. Bolt 1 2 003070 34 5 6 7 For higher speed operation 1. Angle housing 2. Joint 3. Socket 4. Spindle 5. Low 6. High 7. Two faces 003071 To install the socket and the joint, fit the socket to the spindle so that the two faces are fitted perfectly. Then install the joint. For higher speed operation, fit the angle housing marked "LOW" to the joint. For lower speed operation, fit the angle housing marked "HIGH" to the joint. Rotate the angle housing to the desired position. Tighten the bolt with the hex wrench firmly. And retighten the another bolt firmly again. CAUTION: • Be sure to tighten the two bolts firmly, or it may present a risk of injury to persons. 9