Makita DCJ205ZL DCJ205Z DCJ206Z Instruction Manual - Page 10
Functional, Description
View all Makita DCJ205ZL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
FUNCTIONAL DESCRIPTION Power button To turn on the jacket or vest, press and hold the power button (about 1.5 seconds). To turn off, press and hold the power button again. Temperature adjustment There are three temperature settings (high, medium, low). When you switch on the jacket or vest, the temperature is set to "high". Each time you press the power button, the temperature setting changes as shown in the figure. The color of the power button shows the current setting. ► Fig.11: 1 . Red: "high" 2. White: "medium" 3. Blue: "low" Indicating the remaining battery capacity Only for battery cartridges with the indicator ► Fig.12: 1 . Indicator lamps 2. Check button Press the check button on the battery cartridge to indicate the remaining battery capacity. The indicator lamps light up for a few seconds. Indicator lamps Remaining capacity Lighted Off Blinking 75% to 100% 50% to 75% 25% to 50% 0% to 25% (For 14.4 V and 18 V batteries only) Charge the battery. The battery may have malfunctioned. Battery protection system The device is equipped with a battery protection system. This system automatically cuts off power to the heating parts to extend battery life. If the remaining battery capacity is too low, the device will not operate. When you turn the device on, the power is supplied to the heating parts again, but stops soon. In this situation, remove and recharge the battery cartridge. Connecting USB devices CAUTION: Connect only devices that are compatible with the USB power supply port. Not doing so may cause a malfunction of the battery holder. NOTICE: Before connecting a USB device to the battery holder (with the battery), always back up the data on the USB device. Not doing so may cause a loss of your data. The battery holder (with the battery cartridge) can work as an external power supply for USB devices. Open the cover and connect a USB cable (not included) to the power supply port of the battery holder. Then connect the other end of the cable to the device and turn on the switch next to the USB port. The battery holder (with the battery cartridge) supplies DC 5 V, 2.4 A (maximum). ► Fig.13: 1 . Cover 2. Switch The USB cable can be placed inside the jacket or vest for convenience using the hole in the pocket and the cable holder. For CJ105D / DCJ205 / CJ106D / DCJ206 ► Fig.14: 1 . USB cable For CV102D / DCV202 ► Fig.15: 1 . USB cable NOTE: The battery holder may not supply power to some USB devices. NOTE: When not in use or after charging, remove the USB cable and close the cover. NOTE: Battery power is consumed while the switch is turned on. Always turn off the switch when not in use. NOTE: When charging multiple USB devices in succession, wait about 10 seconds after charging of the previous device has completed before beginning to charge the next device. (For 14.4 V and 18 V batteries only) NOTE: Depending on the conditions of use and the ambient temperature, the indication may differ slightly from the actual capacity. 10 ENGLISH