Makita DCL501Z DCL501 Instruction Manual - Page 6

If the appliance does not start, the battery is overheated. In this situation, let the battery cool before restarting the appliance. • Low battery voltage: The remaining battery capacity is too low and the appliance will not operate. In this situation, remove and recharge the battery. Installing or removing attachments CAUTION: • Always be sure that the appliance is switched off and the battery cartridge is removed before carrying out any work on the appliance. • Firmly push the nozzle or zoom pipe into the handle while twisting to securely attach to ensure that they do not come loose during use. Attach the hose connector to the suction hose opening on the appliance. Press the release button to disconnect the hose. 1. Release button 2. Suction hose opening 1 Attach the nozzle to the zoom pipe. 1. Nozzle 1 Attach the crevice nozzle to the handle or zoom pipe to use to clean crevices and other narrow, hard-to-reach areas. 1. Crevice nozzle 1 CAUTION: • Do not cover the hole of the crevice nozzle. It may cause overheat and result in damage to the appliance. 2 Insert the zoom pipe into the end of the handle. 1. Handle 1 2. Zoom pipe 2 Loosen the zoom pipe ring and adjust the pipe length. After adjustment, tighten the ring. 1. Ring 1 6 Attaching the shoulder belt CAUTION: • When hanging the appliance on your shoulder, always hold the appliance itself by hand to prevent it from dropping. Dropping the appliance may cause injury or property damage. Use the shoulder belt to hang the appliance on your shoulder for cleaning a high place. Loop the shoulder belt around both the carrying handle and the belt holder and then run it through the stopper as shown in the diagram.