Makita FD07R1 FD07 Instruction Manual - Page 7

Before actual operation, drive a trial screw into your material or a piece of duplicate material to determine which torque level is required for a particular application. The following shows the rough guide of the relationship between the screw size and graduation. Graduation 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 Machine screw M4 M5 M6 Wood Soft wood - ɸ3.5 x 22 ɸ4.1x 38 - screw (e.g. pine) Hard wood - (e.g. lauan) ɸ3.5 x 22 ɸ4.1x 38 - ASSEMBLY CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Installing or removing driver bit/ drill bit For Model FD07 (optional accessory) Use only the driver bit/socket bit shown in the figure. Do not use any other driver bit/socket bit. 1 2 1 3 2 ► 1 . Sleeve 2. Close 3. Open Turn the sleeve counterclockwise to open the chuck jaws. Place the driver bit/drill bit in the chuck as far as it will go. Turn the sleeve clockwise to tighten the chuck. To remove the driver bit/drill bit, turn the sleeve counterclockwise. Installing or removing driver bit/ socket bit For Model FD08 (optional accessory) ► 1 . Driver bit 2. Sleeve To install the driver bit, pull the sleeve in the direction of the arrow and insert the driver bit into the sleeve as far as it will go. Then release the sleeve to secure the driver bit. To remove the driver bit, pull the sleeve in the direction of the arrow and pull the driver bit out. NOTE: If the driver bit is not inserted deep enough into the sleeve, the sleeve will not return to its original position and the driver bit will not be secured. In this case, try re-inserting the bit according to the instructions above. NOTE: After inserting the driver bit, make sure that it is firmly secured. If it comes out, do not use it. Installing hook 12 mm (15/32") 9 mm (3/8") 1 ► 1 . Groove 2. Hook 3. Screw 2 3 7 ENGLISH