Makita GA7911 Owners Manual - Page 8

ASSEMBLY 1. Lock nut 2. Abrasive disc 3. Rubber pad 1 2 CAUTION: • Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. 001059 Installing side grip (handle) CAUTION: • Always be sure that the side grip is installed securely before operation. Screw the side grip securely on the position of the tool as shown in the figure. 001114 Installing or removing abrasive disc 1 (optional accessory) 2 NOTE: 3 • Use sander accessories specified in this manual. These must be purchased separately. Mount the rubber pad onto the spindle. Fit the disc on the rubber pad and screw the lock nut onto the spindle. 001621 To tighten the lock nut, press the shaft lock firmly so that the spindle cannot revolve, then use the lock nut wrench and securely tighten clockwise. To remove the disc, follow the installation procedure in reverse. 1. Lock nut wrench 2. Shaft lock 8 IF USED AS A GRINDER NOTE: • Use grinder accessories specified in this manual. These must be purchased by separate. WARNING: • Always use guard assembly or accessory kit, noted below, for type 27 depressed center grinding wheel/ Multi-disc.