Makita GV7000C Owners Manual - Page 8
Operation, Maintenance
View all Makita GV7000C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
1 2 3 1. Lock nut 2. Abrasive disc 3. Rubber pad 4. Spindle 1 003414 Installing or removing abrasive disc Mount the rubber pad onto the spindle. Fit the abrasive disc on the rubber pad and screw the lock nut onto the spindle. 4 003418 To tighten the lock nut, hold the spindle with the wrench so that it cannot revolve, then use the lock nut wrench and securely tighten clockwise. 2 To remove the disc, follow the installation procedure in reverse. 1. Lock nut wrench 2. Wrench OPERATION 003421 Sanding operation CAUTION: • Always wear safety goggles or a face shield during operation. 15 • Never run the tool without the abrasive disc. You may seriously damage the pad. Hold the tool firmly. Turn the tool on and then apply the abrasive disc to the workpiece. In general, keep the abrasive disc at an angle of about 15 degrees to the workpiece surface. Apply slight pressure only. Excessive pressure will result in poor performance and premature wear to abrasive disc. MAINTENANCE 8 CAUTION: • Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance.