Makita HP2010N Owners Manual - Page 7
Assembly - handle
View all Makita HP2010N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
1 1. Change lever 002853 Speed change Two speed ranges can be preselected with the speed change lever. To change the speed, press the speed change lever and slide it to the "L" position for low speed or the "H" position for high speed. If the speed change lever does not slide easily, turn the chuck slightly in either direction while sliding the lever. Be sure that the speed change lever is set to the correct position before operation. Use the right speed for your job. CAUTION: • Always set the speed change lever fully to the correct position. If you operate the tool with the speed change lever positioned halfway, the tool may be damaged. • Do not use the speed change lever while the tool is running. The tool may be damaged. 1. Change ring 002854 1 Selecting the action mode This tool has an action mode changing ring. For rotation with hammering, turn the ring in the direction of multiple arrow indication. For rotation only, turn the ring in the direction of single arrow indication. CAUTION: • Always turn the change ring fully to your desired mode mark. If you operate the tool with the ring halfway, the tool may be damaged. ASSEMBLY CAUTION: • Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. 002458 Installing side grip (auxiliary handle) Always use the side grip to ensure operating safety. Install the side grip on the tool barrel. Then tighten the thumb screw securely at the desired position. It may be swung 360° so as to be secured at any position. 7