Makita HR2621 Owners Manual - Page 6
Assembly
View all Makita HR2621 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
• Do not force the action mode change knob or do not move it from symbol mode to symbol mode (or vise versa) at once. It may damage the tool. When turning the knob from symbol mode to symbol mode (or vise versa), stop it at symbol mode once. And rotate the chuck clockwise (looking from the chuck side) half turn or until it clicks. Then turn the knob to the desired mode. If it is still difficult to turn the knob, rotate the chuck again. Torque limiter The torque limiter will actuate when a certain torque level is reached. The motor will disengage from the output shaft. When this happens, the bit will stop turning. CAUTION: • As soon as the torque limiter actuates, switch off the tool immediately. This will help prevent premature wear of the tool. • Bits such as hole saw, which tend to pinch or catch easily in the hole, are not appropriate for this tool. This is because they will cause the torque limiter to actuate too frequently. Hook CAUTION: • Never hook the tool at high location or on potentially unstable surface. 1. Hook 1 ASSEMBLY CAUTION: • Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Side grip (auxiliary handle) 1 1. Protrusions 2. Grooves 2 014500 CAUTION: • Always use the side grip to ensure operating safety. Install the side grip so that the protrusions on the grip fit in between the grooves on the tool barrel. Then tighten the grip by turning clockwise at the desired position. It may be swung 360° so as to be secured at any position. Bit grease Coat the bit shank head beforehand with a small amount of bit grease (about 0.5 - 1 g). This chuck lubrication assures smooth action and longer service life. Installing or removing the bit 1 2 1. Bit shank 2. Bit grease 014368 The hook is convenient for hanging the tool temporarily. To use the hook, simply lift up hook until it snaps into the open position. When not in use, always lower hook until it snaps into the closed position. 003150 Clean the bit shank and apply bit grease before installing the bit. 1. Bit 1 014430 6