Makita HR2621 Owners Manual - Page 8
Dust cup optional accessory
View all Makita HR2621 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
NOTE: • Inserting the depth gauge with its toothed side not directed to the toothed side of hex hole marking on the grip base as shown in the figure does not allow the depth gauge to be locked. Dust cup (optional accessory) 1. Dust cup 1 010731 Use the dust cup to prevent dust from falling over the tool and on yourself when performing overhead drilling operations. Attach the dust cup to the bit as shown in the figure. The size of bits which the dust cup can be attached to is as follows. Bit diameter Dust cup 5 6 mm (1/4") - 14.5 mm (9/16") Dust cup 9 12 mm (15/32") - 16 mm (5/8") 006386 There is another type of dust cup which helps you prevent dust from falling over the tool and on yourself when performing overhead drilling operations. Installing or removing the dust cup (optional accessory) 1. symbol 1 2 2. Grooves 3. Dust cup 3 014436 Before installing the dust cup, remove the bit from the tool if installed on the tool. Install the dust cup on the tool so that the symbol on the dust cup is aligned with the grooves in the tool. 1. Bit 2. Chuck cover 2 1 014435 To remove the dust cup, pull the chuck cover in the direction as shown in the figure and with the chuck cover pulled take the bit out of the tool. 1. Attachment at the 1 foot of dust cup 014441 And then grab the attachment at the foot of dust cup and take it out. 1. Bellows 1 2. Attachment 011507 1 2 012895 2 3 4 5 1. Inside periphery 2. Carved side 3. Attachment 4. Cap 5. Groove 8