Makita HR2651 HR2651/HR2661 Instruction Manual - Page 8
Chisel angle when chipping, scaling or demolishing, Depth gauge, Installing or removing dust,
View all Makita HR2651 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
NOTE: Make sure that the depth gauge does not touch the main body of the tool when attaching it. Installing or removing dust 2 1 collection system To remove the dust collection system, pull the tool while pressing the lock-off button. To install it, insert the tool into the dust collection system all the way until it locks in place with a little click. ► 1 . Drill bit 2. Chuck cover Chisel angle (when chipping, scaling or demolishing) The chisel can be secured at the desired angle. To change the chisel angle, rotate the action mode changing knob to the O symbol. Turn the chisel to the desired angle. 1 ► 1 . Action mode changing knob Rotate the action mode changing knob to the symbol. Then make sure that the chisel is securely held in place by turning it slightly. Depth gauge The depth gauge is convenient for drilling holes of uniform depth. Loosen the side grip and insert the depth gauge into the hole on the side grip. Adjust the depth gauge to the desired depth and tighten the side grip firmly. 1 ► 1 . Lock-off button Dust cup Optional accessory Use the dust cup to prevent dust from falling over the tool and on yourself when performing overhead drilling operations. Attach the dust cup to the bit as shown in the figure. The size of bits which the dust cup can be attached to is as follows. Model Dust cup 5 Dust cup 9 Bit diameter 6 mm (1/4") - 14.5 mm (9/16") 12 mm (15/32") - 16 mm (5/8") 1 1 2 ► 1 . Hole 2. Depth gauge ► 1 . Dust cup Dust cup set Optional accessory Before installing the dust cup set, remove the bit from the tool if installed. Install the dust cup set on the tool so that the symbol on the dust cup is aligned with the groove in the tool. 8 ENGLISH