Makita JN3200 Owners Manual - Page 5

How to use Pre-lubrication The cutting line should be pre-lubricated with the following. For mild steel or stainless, use machine oil for aluminum light oil or kerosene. Switch operation - * T o start the tool, simply pull the trigger. Release the trigger t o stop. For continuous operation without having to keep your finger on the trigger, just pull the trigger and then push in the lock button with your thumb. To stop the tool from the lock position, simply pull the trigger again and release it. Lock button Permissible cutting thickness *The thickness of material to be cut de- pends upon the tensile strength of the material itself. The groove on the die holder acts as a thickness gauge. Do not attempt t o cut any material which will not fit into this groove. Material Mild steel Stain Iess (kg mm2) thickness Cutting procedure *Smooth nibbling i s achieved by holding the nibbler upright and applying gentle pressure in the cutting direction. For clean cutting apply oil to the punch about every 10 meters (32.8 feet) of a material cut. 5