Makita JR3051T JR3051T Instruction Manual - Page 6

2. Insert the square nuts into the tool as shown in the figure. 3. Secure the hook with the screws. 2 3 Insert the recipro saw blade into the blade clamp as far as it will go. The blade clamp sleeve rotates and fixes the recipro saw blade. Make sure that the recipro saw blade cannot be extracted even though you try to pull it out. 1 1 ► 1 . Square nut 2. Hook 3. Screw ASSEMBLY CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Installing or removing the recipro saw blade CAUTION: Always clean out all chips or foreign matter adhering to the blade and around the blade clamp. Failure to do so may cause insufficient tightening of the blade, resulting in a serious injury. Before installing the recipro saw blade, always make sure that the blade clamp lever (part of the blade clamp sleeve) is in released position on the insulation cover. If the blade clamp lever is in fixed position, rotate the blade clamp lever in the direction of the arrow so that it can be locked at the released position . 1 2 3 ► 1 . Blade clamp lever 2. Released position 3. Fixed position 2 ► 1 . Recipro saw blade 2. Blade clamp sleeve CAUTION: If you do not insert the recipro saw blade deep enough, the recipro saw blade may be ejected unexpectedly during operation. This can be extremely dangerous. To remove the recipro saw blade, rotate the blade clamp lever in the direction of the arrow fully. The recipro saw blade is removed and the blade clamp lever is fixed at the released position . 2 1 ► 1 . Recipro saw blade 2. Blade clamp lever CAUTION: Keep hands and fingers away from the lever during the switching operation. Failure to do so may cause personal injuries. NOTE: If you remove the recipro saw blade without rotating the blade clamp lever fully, the lever may not be locked in the released position . In this case, rotate the blade clamp lever fully again, then make sure that the blade clamp lever locked at the released position . NOTE: If the blade clamp lever is positioned inside the tool, switch on the tool just a second to let the blade out. Unplug the tool before installing or removing the recipro saw blade. 6 ENGLISH