Makita LS1019L LS1019L Instruction Manual - Page 11
Adjusting the bevel angle
View all Makita LS1019L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
2. Pull and turn the latch lever to the position as 1 illustrated. 2 3 1 4 ► 1 . Lock lever 2. Grip 3. Releasing lever 4. Pointer Rotate the grip counterclockwise to unlock the turn base. Turn the grip while holding down the lock lever to move the turn base. Align the pointer with your desired angle on the scale then tighten the grip. NOTE: If you depress the releasing lever, you can move the turn base without holding down the lock lever. Tighten the grip at your desired position. This miter saw employs positive stop function. You can set 0°, 15°, 22.5°, 31.6°, 45°, and 60° right/left miter angle quickly. To use this function, move the turn base close to your desired positive stop angle while holding down the lock lever. Then release the lock lever and move the turn base forward until the turn base is locked. Adjusting the bevel angle NOTICE: Always remove the upper guide fences and vertical vise before adjusting the bevel angle. NOTICE: When changing bevel angles, be sure to position the kerf boards appropriately as explained in the "Kerf boards" section. NOTICE: When tilting the saw blade, be sure to raise the handle fully. 1. Turn the knob on the slide pole counterclockwise. ► 1 . Latch lever 3. Match the pointer with your desired angle on the scale by moving the carriage then tighten the knob. 1 2 ► 1 . Bevel angle scale 2. Pointer To tilt the carriage to the right, tilt the carriage to the left slightly and then tilt it to the right while pressing down the releasing button. ► 1 . Knob 1 11 ENGLISH