Makita LS1019L LS1019L Instruction Manual - Page 24
Table C
View all Makita LS1019L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Crown molding stopper Optional accessory Crown molding stoppers allow easier cuts of crown molding without tilting the saw blade. Install them on the 1 turn base as shown in the figures. At right 45° miter angle 1 2 3 4 2 ► 1 . Guide fence 2. Crown molding stopper ► 1 . Crown molding stopper L 2. Crown molding stopper R 3. Turn base 4. Guide fence At left 45° miter angle 1 (a) (b) 1 (c) (d) 2 2 3 4 ► 1 . Crown molding stopper L 2. Crown molding stopper R 3. Turn base 4. Guide fence Position crown molding with its WALL CONTACT EDGE against the guide fence and its CEILING CONTACT EDGE against the crown molding stoppers as shown in the figure. Adjust the crown molding stoppers according to the size of the crown molding. Tighten the screws to secure the crown molding stoppers. Refer to the table (C) for the miter angle. 1. Inside corner 2. Outside corner Table (C) - For inside corner For outside corner Molding position in the figure (a) (b) (c) (d) Miter angle Finished piece Right 45° Left 45° Right 45° Save the right side of blade Save the left side of blade Save the right side of blade Save the left side of blade 24 ENGLISH