Makita MP100DZ MP100D Instruction Manual - Page 7
Pressure gauge, Lighting up the front lamp, Storing adapter, Storing hose
View all Makita MP100DZ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Pressure gauge 1 Storing adapter 2 3 12 3 ► 1 . Unit button 2. Minus button 3. Plus button If the object to be inflated is connected to the tool, the air pressure of the object is displayed on the pressure gauge when you turn on the tool. If nothing is connected to the tool, the pressure gauge displays "0". You can set the air pressure on the pressure gauge. To change the unit, press the unit button. To increase the pressure value, press the plus button. To decrease the pressure value, press the minus button. You can set the pressure value between 20 kPa (3 PSI) and 830 kPa (121 PSI). Lighting up the front lamp ► 1 . Sport ball needle 2. Presta valve adapter 3. Adapter holder The adapters can be stored in the adapter holder of the tool. Insert the sport ball needle into the Presta valve adapter before attaching them to the adapter holder. Storing hose 1 2 1 2 ► 1 . Hose holder 2. Hose The hose can be attached to the hose holder of the tool. ► 1 . Lamp 2. Main power switch CAUTION: Do not look in the light or see the source of light directly. When you turn on the tool by pressing the main power switch, the lamp lights up. When you turn off the tool by pressing the main power switch, the lamp goes out. NOTICE: When the tool is overheated, the lamp flickers. Cool down the tool fully before operating the tool again. NOTE: Use a dry cloth to wipe the dirt off the lens of the lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. 7 ENGLISH