Makita MT01Z MT01 Instruction Manual - Page 7
Assembly
View all Makita MT01Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
ASSEMBLY 3 CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Installing or removing application tool Optional accessory WARNING: Do not install application tool upside down. Installing application tool upside down may damage the tool and cause serious personal injury. NOTE: Install application tool in the correct direction according to your work. Application tool can be installed at an angle of every 30 degree. To Install an application tool (optional accessory), put the application tool on the tool flange so that the protrusions of the tool flange fit in the holes in the application tool. Then secure the application tool by tightening the bolt firmly with the hex wrench. 2 3 2 1 Fig.8 ► 1 . Sanding pad 2. Tighten 3. Sanding paper To remove the sanding paper, raise its end and peel it off. When using application tools with a different type of installation section, use a correct adapter (optional accessory). 2 1 3 1 Fig.6 ► 1 . Protrusions of the tool flange 2. Holes in the application tool 3. Application tool installation bolt 2 1 4 Fig.9 ► 1 . Application tool installation bolt 2. Holes in the application tool 3. Adapter (required for some application tools) 4. Protrusions of the tool flange Hex wrench storage 3 Fig.7 ► 1 . Application tool installation bolt 2. Hex wrench 3. Tighten To remove the application tool, loosen and remove the application tool installation bolt using a hex wrench and then take off the application tool. When using the tool as a sander, set a sanding paper on the sanding pad (hook and loop fitting). Make sure that their shape and dust extraction holes match each other when setting. Fig.10 1 ► 1 . Hex wrench When not in use, store the hex wrench as shown in the figure to keep it from being lost. 7 ENGLISH