Makita MT01Z MT01 Instruction Manual - Page 8
Operation
View all Makita MT01Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
OPERATION WARNING: Before starting the tool and during operation, keep your hand and face away from the application tool. CAUTION: Do not apply excessive load to the tool which may cause a motor lock and stop the tool. CAUTION: Do not operate the tool with pressing the battery cartridge against the tool. Cutting, sawing and scraping CAUTION: Do not move on the tool forcibly in the direction (eg. towards either side) of tool application with no cutting edge. It may damage the tool. NOTE: Using a test material sample to try is recommendable to determine a correct orbital stroke rate suitable for your work. NOTE: Use a sanding paper with the same grit until sanding the whole workpiece is completed. Replacing a sanding paper with different grit sanding paper may not get a fine finish. Dust extraction attachment Optional accessory CAUTION: Do not use the dust extraction attachment when sanding metal. Sucking spark and hot particle results in smoking and ignition. 5 Fig.11 Put the application tool on the workpiece. And then move the tool forward so that the application tool movement does not slow down. NOTE: Forcing or excessive pressure on the tool may reduce efficiency. NOTE: Before cutting operation, it is recommended to preset the orbital stroke rate 3 - 5. Sanding CAUTION: Do not reuse a sanding paper used for sanding metal to sand wood. CAUTION: Do not use a worn sanding paper or sanding paper without grit. Apply a sanding paper on the workpiece. 2 1 4 3 6 7 8 Fig.13 ► 1 . Dust nozzle 2. Joint 3. Dust attachment 4. Nozzle band 5. Holes in the tool 6. Felt ring 7. Sanding pad 8. Application tool installation bolt 1. Install joint, dust nozzle and dust attachment. 2. Install the nozzle band on the tool so that its protrusions fit in the holes in the tool to secure it. 3. Put the felt ring and the sanding pad on the dust attachment and then secure them with the application tool installation bolt. To perform cleaner operation, connect a vacuum cleaner to the tool. Connect a hose of vacuum cleaner to the dust extraction attachment (optional accessory). Fig.12 8 ENGLISH