Makita PO5000C Makita PO5000CX1 Instruction Manual - Page 6
Assembly
View all Makita PO5000C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
NOTICE: Always turn the knob fully. If the knob is in the middle position, you can not turn on the tool. NOTICE: You can not change the action mode when the tool is switched on. Random orbit with forced rotation mode Installing the backing pad 2 1 Random orbit with forced rotation mode is orbital action with forced rotation of the pad for rough polishing such as surface treatment. Rotate the change knob counterclockwise for random orbit with forced rotation mode. Random orbit mode ► 1 . Backing pad 2. Hex wrench Put the backing pad on the shaft then turn the bolt clockwise with a hex wrench. CAUTION: Make sure that the backing pad is secured properly. Loose attachment will run out of balance and cause a excessive vibration which may cause loss of control. Installing side grip Optional accessory 1 Random orbit mode is orbital action with free rotation of the pad for fine polishing. Rotate the change knob clockwise for random orbit 2 mode. ASSEMBLY CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. ► 1 . Cap 2. Side grip Remove the cap and screw the side grip on the tool securely. The side grip can be installed on either side of the tool. 6 ENGLISH