Makita RT0701CX3 Owners Manual - Page 12
Templet guide optional accessory, Dust nozzle sets, optional accessory
View all Makita RT0701CX3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
1. Guide bar 1 2. Wing bolt 3. Straight guide 2 1. Screw 2. Base 3. Templet 1 2 3 011849 To install the straight guide, insert the guide bars into the holes in the plunge base. Adjust the distance between the bit and the straight guide. At the desired distance, tighten the wing bolts to secure the straight guide in place. When cutting, move the tool with the straight guide flush with the side of the workpiece. A 011850 If the distance (A) between the side of the workpiece and the cutting position is too wide for the straight guide, or if the side of the workpiece is not straight, the straight guide cannot be used. In this case, firmly clamp a straight board to the workpiece and use it as a guide against the router base. Feed the tool in the direction of the arrow. Templet guide (optional accessory) 3 011852 Secure the templet to the workpiece. Place the tool on the templet and move the tool with the templet guide sliding along the side of the templet. 1 7 2 3 4 5 6 1. Bit 2. Base 3. Templet 4. Workpiece 5. Distance (X) 6. Outside diameter of the templet guide 7. Templet guide 003695 NOTE: • The workpiece will be cut a slightly different size from the templet. Allow for the distance (X) between the bit and the outside of the templet guide. The distance (X) can be calculated by using the following equation: Distance (X) = (outside diameter of the templet guide - bit diameter) / 2 Dust nozzle sets (optional accessory) For the trimmer base 011851 The templet guide provides a sleeve through which the bit passes, allowing use of the tool with templet patterns. To install the templet guide, loosen the screws on the tool base, insert the templet guide and then tighten the screws. 1 1. Dust nozzle 2. Thumb screw 3. Trimmer base 011989 3 2 12