Makita RW01R1 RW01 Instruction Manual - Page 7

ASSEMBLY CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Installing or removing socket adaptor To install the socket adaptor, push it into the adaptor hole until it locks into place. 1 Installing or removing socket CAUTION: Before operation, make sure that the socket is properly locked onto the socket adaptor. Incomplete attachment of the socket may cause injury. NOTICE: Always use the correct size socket for bolt/ nut. An incorrect size socket will result in inconsistent fastening torque and/or damage to the bolt/nut. To install the socket, push it onto the socket adaptor until it locks into place. To remove the socket, simply pull it off. 1 2 2 ► 1 . Socket adaptor 2. Adaptor hole To remove the socket adaptor, insert a stick like a screwdriver into the backside of the socket adaptor, and then tap it gently. ► 1 . Socket 2. Socket adaptor OPERATION CAUTION: Hold the tool firmly especially 1 when the bolt/nut reaches the seating position. The socket stops rotating and the motor reaction generate instant backlash to rotate the tool. 2 NOTICE: Hold the tool pointed straight at the bolt/nut. Hold the tool firmly and place the socket over the bolt/nut. Turn the tool on and fasten. When the bolt/ nut reaches the seating position, the tool stops automatically. ► 1 . Socket adaptor 2. Screwdriver NOTICE: During removal procedure, keep holding the socket adaptor to prevent it from falling off from the tool. 7 ENGLISH