Makita TD022DSE TD022D Instruction Manual - Page 6

Installing or removing driver bit/ socket bit 1 Optional accessory 12 mm (15/32") 9 mm (3/8") 2 Use only the driver bit/socket bit shown in the figure. Do not use any other driver bit/socket bit. 1 2 ► 1 . Driver bit 2. Sleeve To install the driver bit, pull the sleeve in the direction of the arrow and insert the driver bit into the sleeve as far as it will go. Then release the sleeve to secure the driver bit. To remove the driver bit, pull the sleeve in the direction of the arrow and pull the driver bit out. NOTE: If the driver bit is not inserted deep enough into the sleeve, the sleeve will not return to its original position and the driver bit will not be secured. In this case, try re-inserting the bit according to the instructions above. NOTE: After inserting the driver bit, make sure that it is firmly secured. If it comes out, do not use it. ► 1 . Straight shape 2. Pistol shape The tool can be used in two ways; a straight shape and a pistol shape which are selectable according to the conditions of workplace and screwdriving. The proper fastening torque may differ depending upon the kind or size of the screw/bolt, the material of the workpiece to be fastened, etc. The relation between fastening torque and fastening time is shown in the figures. Standard bolt N•m (ft•lbs) 20 (15) 15 (11) 2 10 (7) 5 (4) M8(5/16") M6(1/4") M8(5/16") 3 M6(1/4") 0 1 2 3 1 1. Fastening time (second) 2. Fastening torque 3. Proper fastening torque corresponding to each bolt diameter OPERATION CAUTION: When bending the tool to use in the pistol shape or straightening to use in the straight shape, do not hold the bendable part of the tool. Failure to do so may cause your hand and fingers to be pinched and injured by this part. 6 ENGLISH