Makita TP03Z TP03 Instruction Manual - Page 6
Trigger-lock button, Adjusting the depth of pin-nailing, Lighting up the lamp
View all Makita TP03Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Trigger-lock button CAUTION: Before installing the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. CAUTION: When not operating the tool, depress the trigger-lock button from B side to lock the switch trigger in the OFF position. 1 A ► 1 . Adjuster 1 2 2 1 B 3 ► 1 . Trigger-lock button 2. Switch trigger ► 1 . Too deep 2. Flush 3. Too shallow B Lighting up the lamp A To prevent the switch trigger from accidentally pulled, the trigger-lock button is provided. To pull the switch trigger, depress the trigger-lock button from A side. After use, always press in the trigger-lock button from B side. Adjusting the depth of pin-nailing CAUTION: Do not look in the light or see the source of light directly. Pull the switch trigger or actuate the contact element to light up the lamp. The lamp keeps on lighting while pulling the switch trigger or actuating the contact element. The lamp goes out approximately 10 seconds after releasing the switch trigger and the contact element. WARNING: Always make sure that your fingers are not placed on the switch trigger or the contact element and the battery cartridge is removed before adjusting the depth of nailing. Depth of pin-nailing can be adjusted on this pin nailer. To adjust the depth of nailing, turn the adjuster. The depth of nailing is the deepest when the adjuster is turned fully in the A direction shown in the figure. It will become shallower as the adjuster is turned in the B direction. Depth can be adjusted 1.5 mm to the maximum. 1 ► 1 . Lamp NOTE: Use a dry cloth to wipe the dirt off the lens of the lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. NOTE: Even in the lamp lights up when the battery power residual gets small, pin nailer may not fire pin nails. In this case, charge the battery cartridge. 6 ENGLISH