Makita TP03Z TP03 Instruction Manual - Page 8
Operation
View all Makita TP03Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
1 2 3 ► 1 . Groove 2. Hook 3. Screw Hex wrench storage When not in use, store the hex wrench as shown in the figure to keep it from being lost. Test safety systems for possible fault before operation as follows. 1. Unload pin nails from the tool and keep the magazine opened. 2. Install the battery cartridge and release the trigger lock. 3. Only pull the switch trigger without touching the contact element against the material. 4. Only touch the contact element against the material without pulling the switch trigger. If the tool operates in the case of 3 and 4 above, the safety systems are faulty. Stop using the tool immediately and ask your local service center. Driving pin nails WARNING: Continue to place the contact element firmly on the material until the pin nail is driven completely. Unintentional firing may cause personal injuries. 1. Release the trigger lock. 2. Place flat the contact element on the material. 3. Pull the switch trigger fully to drive a pin nail. 4. To drive the next pin nail, release your finger from the switch trigger once, and then repeat the step 2 and 3 above. 1 1 ► 1 . Hex wrench OPERATION Testing the safety system WARNING: Make sure all safety systems are in working order before operation. Failure to do so may cause personal injuries. 1 2 ► 1 . Switch trigger 2. Contact element You can also drive the pin nails when dragging the tool to the next area with the contact element pressed against the material and pulling the switch trigger. 2 4 3 ► 1 . Trigger-lock button 2. Switch trigger 3. Contact element 4. Magazine 8 ENGLISH