Makita UH6570 Owners Manual - Page 9

1. Crank 1 1. Crank 1 009300 009304 Overlap the oval hole in the upper blade with that in the lower one. 1. Ellipse of shear 1 blade 009301 Take out the blade cover from the old shear blades and fit it onto the new ones for easy handling during the replacement of blades. Install the gear housing, under cover on the tool. Tighten the screw firmly. Remove the blade cover and then turn on the tool to check it for proper movement. NOTE: • When the shear blades does not operate properly, there is a poor fit between the blades and crank. Redo from the beginning. Storage The hook hole in the bottom of the blade cover is convenient for hanging the tool from a nail or screw on the wall. 009305 009302 Place the new shear blades on the tool so that the oval holes in the shear blades fit onto the crank. Overlap the holes in the shear blades with the screw holes in the tool and then secure them with two screws. 1 1. Ellipse of shear blade 2. Crank 2 009303 Check the crank for smooth turn with a slotted bit screwdriver. Put the blade cover on the shear blades so that the blades are not exposed. Store the tool out of the reach of children carefully. Store the tool in the place not exposed to water and rain. To maintain product SAFETY and RELIABILITY, repairs, carbon brush inspection and replacement, any other maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts. ACCESSORIES CAUTION: • These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. 9